Paper
25 April 2022 Load analysis of roof photovoltaic arrays and evaluation of structural bearing capacity
Li Mo, Guo’an Wei
Author Affiliations +
Proceedings Volume 12244, 2nd International Conference on Mechanical, Electronics, and Electrical and Automation Control (METMS 2022); 1224423 (2022) https://doi.org/10.1117/12.2634899
Event: 2nd International Conference on Mechanical, Electronics, and Electrical and Automation Control (METMS 2022), 2022, Guilin, China
Abstract
As a clean energy source, solar energy has been mainly applied to solar power generation with broad application prospects. Due to the present tense situation of land use, solar power generation generally resorts to the existing buildings for the power generation-building integration. For the buildings with newly added photovoltaic power generation equipment, whether the existing buildings meet the relevant bearing capacity requirements after the addition of equipment loads should be checked. The load calculation for photovoltaic power generation equipment has not been specially expounded in any national code. Therefore, the design standards used are varied. In this study, a relatively conventional load calculation method and an evaluation method for buildings’ bearing capacity were proposed after comparing the calculation results by reference to domestic (Chinese) and foreign existing design experience and relevant codes currently in force.
© (2022) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Li Mo and Guo’an Wei "Load analysis of roof photovoltaic arrays and evaluation of structural bearing capacity", Proc. SPIE 12244, 2nd International Conference on Mechanical, Electronics, and Electrical and Automation Control (METMS 2022), 1224423 (25 April 2022); https://doi.org/10.1117/12.2634899
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Photovoltaics

Solar cells

Solar energy

Buildings

Safety

Beam shaping

Reliability

RELATED CONTENT

Hot spot evaluation of photovoltaic modules
Proceedings of SPIE (September 10 2008)
A Solaria white paper
Proceedings of SPIE (September 19 2011)
Product reliability and thin-film photovoltaics
Proceedings of SPIE (August 20 2009)

Back to Top