Analysis on resin removal in laser drilling of printed circuit board

Satoru Noguchi; Etsuji Ohmura; Isamu Miyamoto

doi:10.1117/12.499621

19 February 2003 Analysis on resin removal in laser drilling of printed circuit board

Satoru Noguchi, Etsuji Ohmura, Isamu Miyamoto

Proceedings Volume 4830, Third International Symposium on Laser Precision Microfabrication; (2003) https://doi.org/10.1117/12.499621
Event: LAMP 2002: International Congress on Laser Advanced Materials Processing, 2002, Osaka, Japan

Abstract

On laser drilling of printed circuit board, one-dimensional non-steady heat conduction problem of two-layers composed of resin and metal was analyzed with the finite element method (FEM), considering resinous evaporation. Validity of analysis method was verified by comparing with experimental results. The main conclusions are as follows: (1) Proportionality between latent heat of evaporation and absorptivity can be obtained using the experimental results of removal quantity when resin is thick enough. These values can be estimated simultaneously by comparing analytical results by FEM and experimental results. (2) An equation for rough estimate of maximum removal velocity was derived. (3) Removal quantity is proportional to the number of shots, but its proportionality is lost after layer thickness reaches to absorption length, yielding smear in practical use. Residual smear is caused by heat conduction to substrate during pulse. (4) Removal quantity depends on fluence most, but hardly depends on repetition rate. When resin thickness is larger than absorption length, removal quantity per pulse is proportional to fluence. (5) Removal velocity becomes larger with shorter pulse width. When resin thickness is smaller than absorption length, residual thickness increases as pulse width becomes long.

Citation Download Citation

Satoru Noguchi, Etsuji Ohmura, and Isamu Miyamoto "Analysis on resin removal in laser drilling of printed circuit board", Proc. SPIE 4830, Third International Symposium on Laser Precision Microfabrication, (19 February 2003); https://doi.org/10.1117/12.499621

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE

Includes PDF, HTML & Video, when available