Paper
15 February 1990 Relevant Parameters Study For 1.55 µm Signal Amplification Using 1.48 µm Pumped Erbium-Doped Fibers
J. C. Auge, H. A. Fevrier, P. Bousselet, A. Dursin, J. Ramos
Author Affiliations +
Abstract
We report on a parametric study to optimize the Er3+-doped fiber amplifiers performances. A 24 dB efficient gain in Er3+- doped silica-based fibers has been achieved for small signal regime at 1.553 μm with a 40 mW pump power in the 1.48-1.49 μm range. The saturation output signal power was up to 20 mW for a gain of 17 dB. For the signal wavelength a 3dB-bandwidth of 30 nm has been obtained always with a pump around 1.48 4m. We achieved these results by optimizing the relevant parameters which are the pump and signal characteristics (wavelength and power), the Er3±-concentration and length for the doped fiber. We report on the main parameters which determine the amplifier efficiency (gain, saturation output power, saturation gain, bandwidth, amplified spontaneous emission,...). It is worth noticing that an outstanding amplification is obtained at 1.55 μm wavelength where the gain value is not optimal in order to demonstrate the capability of such amplifiers.
© (1990) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
J. C. Auge, H. A. Fevrier, P. Bousselet, A. Dursin, and J. Ramos "Relevant Parameters Study For 1.55 µm Signal Amplification Using 1.48 µm Pumped Erbium-Doped Fibers", Proc. SPIE 1171, Fiber Laser Sources and Amplifiers, (15 February 1990); https://doi.org/10.1117/12.963145
Lens.org Logo
CITATIONS
Cited by 2 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Optical fibers

Optical amplifiers

Fiber amplifiers

Erbium

Absorption

Fiber lasers

Semiconductor lasers

Back to Top