Paper
1 September 1991 Automated dimensional inspection of cars in crash tests with digital photogrammetry
Horst A. Beyer
Author Affiliations +
Proceedings Volume 1526, Industrial Vision Metrology; (1991) https://doi.org/10.1117/12.48243
Event: Industrial Vision Metrology, 1991, Winnipeg, Canada
Abstract
Changes in the shape of cars due to impact in crash tests are determined from the deformation vectors of points located in specific positions on the car. The coordinates of these points are measured before as well as after the test. Costs and measurement time can be significantly reduced by automated dimensional inspection with digital photogrammetry. This paper reports on a pilot test in which the measurement of a car prepared for a crash test was performed under practical conditions. It was shown that an accuracy of 1 mm in each coordinate axis within a measurement volume of 5 X 2 X 2 m3 can be achieved under factory- floor conditions with low-cost CCD cameras. A high level of automation and robustness was demonstrated. The measurements were performed in a very short time with model-driven techniques.
© (1991) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Horst A. Beyer "Automated dimensional inspection of cars in crash tests with digital photogrammetry", Proc. SPIE 1526, Industrial Vision Metrology, (1 September 1991); https://doi.org/10.1117/12.48243
Lens.org Logo
CITATIONS
Cited by 1 scholarly publication and 1 patent.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Cameras

Photogrammetry

Digital photography

Inspection

Metrology

CCD cameras

Prototyping

Back to Top