Paper
27 December 2001 Measurement and control for mechanical compressive stress
Qing Li, Guang Ye, Lan Pan, Xiushan Wu
Author Affiliations +
Proceedings Volume 4563, Sensors and Controls for Intelligent Manufacturing II; (2001) https://doi.org/10.1117/12.452654
Event: Intelligent Systems and Advanced Manufacturing, 2001, Boston, MA, United States
Abstract
At present, the indirect method is applied to measuring and controlling mechanical compressive stress, which is the measurement and control of rotating torque of screw with torque transducer during screw revolving. Because the friction coefficient between every screw-cap and washer, of screw-thread is different, the compressive stress of every screw may is different when the machinery is equipped. Therefore, the accurate measurement and control of mechanical compressive stress is realized by the direct measurement of mechanical compressive stress. The author introduces the research of contrast between compressive stress and rotating torque in the paper. The structure and work principle of a special washer type transducer is discussed emphatically. The special instrument cooperates with the washer type transducer for measuring and controlling mechanical compressive stress. The control tactics based on the rate of compressive stress is put to realize accurate control of mechanical compressive stress.
© (2001) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Qing Li, Guang Ye, Lan Pan, and Xiushan Wu "Measurement and control for mechanical compressive stress", Proc. SPIE 4563, Sensors and Controls for Intelligent Manufacturing II, (27 December 2001); https://doi.org/10.1117/12.452654
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Sensors

Transducers

Amplifiers

Calibration

Control systems

Interference (communication)

Signal to noise ratio

Back to Top