Paper
26 December 1984 A 100 Mhz Fiber Optic Single Transient Gamma Ray Detection System
J. W. Ogle, R. C. Smith, M. Ward, R. Ramsey, J. Hollabaugh
Author Affiliations +
Abstract
A fiber optic system has been developed to measure single transient gamma rays. The gamma ray signature is converted to light by the Cerenkov process in a 20 cm length of radiation resistant optical fiber. The signal is transmitted over 1 km of optical fiber and detected by state-of-the-art, 175 MHz analog receivers. The receivers are based on silicon PIN detectors with transimpedance hybrid amplifiers and two stages of power amplification. The dc coupled receivers have less than 2% distortion up to 5 volts with less than 10 mV rms noise and a responsivity of 37,500 V/watt at 800 nm. A calibration system measures relative fiber to fiber transit time delays and "system" sensitivity. System bandwidth measurements utilized an electron linear accelerator (Linac) with a 50 ps electron pulse as the Cerenkov light source. The system will be described with supporting calibration and characterization data of parts of the system and the whole system.
© (1984) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
J. W. Ogle, R. C. Smith, M. Ward, R. Ramsey, and J. Hollabaugh "A 100 Mhz Fiber Optic Single Transient Gamma Ray Detection System", Proc. SPIE 0500, Fiber Optics: Short-Haul and Long-Haul Measurements and Applications II, (26 December 1984); https://doi.org/10.1117/12.944595
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Receivers

Stars

Calibration

Fiber optics

Sensors

Fiber optics tests

Gamma radiation

Back to Top