Paper
13 June 2005 A focus sensor for an application in a nanopositioning and nanomeasuring machine
Author Affiliations +
Abstract
A focus sensor on the basis of a hologram laser unit was developed and successfully tested in a nanopositioning and nanomeasuring machine as a zero indicator. The high resolution of the focus sensor is due to a high-precision optical adjustment and special solutions incorporated into the electronic parts. Thus, any sensor malfunctions caused by back-reflected light inside of the assembly could be completely avoided by means of the special high-frequency modulation and laser power stabilization. Common mode noise reduction provides the high SNR of the output signals. The measurements were made according to a dynamic principle by permanent difference formation between the output signal of the focus sensor and the length value of the z-interferometer of the nanopositioning and nanomeasuring machine. The measuring results are presented, and further possibilities of application are outlined.
© (2005) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Rostyslav Mastylo, Denis Dontsov, Eberhard Manske, and Gerd Jager "A focus sensor for an application in a nanopositioning and nanomeasuring machine", Proc. SPIE 5856, Optical Measurement Systems for Industrial Inspection IV, (13 June 2005); https://doi.org/10.1117/12.612887
Lens.org Logo
CITATIONS
Cited by 23 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Sensors

Holograms

CCD image sensors

Semiconductor lasers

Calibration

Standards development

CCD cameras

RELATED CONTENT

Empirical formula for rates of hot pixel defects based on...
Proceedings of SPIE (February 19 2013)
Three-line high-power three-dimensional sensor
Proceedings of SPIE (March 06 1998)
Measurement of drill grinding parameters using laser sensor
Proceedings of SPIE (December 09 2005)
Calibration system for national line standard: a first look
Proceedings of SPIE (September 22 1993)
Quantum efficiency of the XMM pn-CCD camera
Proceedings of SPIE (October 22 1999)

Back to Top