Optical sampling of ultrahigh bitrate signals using highly nonlinear chalcogenide planar waveguides or tapered fibers

Jürgen Van Erps; Feng Luan; Mark D. Pelusi; Eric Mägi; Tim Iredale; Steve Madden; Duk Yong Choi; Douglas A. Bulla; Barry Luther-Davies; Hugo Thienpont; Benjamin J. Eggleton

doi:10.1117/12.853640

4 June 2010 Optical sampling of ultrahigh bitrate signals using highly nonlinear chalcogenide planar waveguides or tapered fibers

Jürgen Van Erps, Feng Luan, Mark D. Pelusi, Eric Mägi, Tim Iredale, Steve Madden, Duk Yong Choi, Douglas A. Bulla, Barry Luther-Davies, Hugo Thienpont, Benjamin J. Eggleton

Author Affiliations +

Proceedings Volume 7728, Nonlinear Optics and Applications IV; 772803 (2010) https://doi.org/10.1117/12.853640
Event: SPIE Photonics Europe, 2010, Brussels, Belgium

Abstract

As the bit rates of optical networks increase, the ability of accurate monitoring of optical waveforms has become increasingly important. In recent years, optical sampling has emerged as a technique to perform time-resolved measurements of optical data signals at high data rates with a bandwidth that cannot be reached by conventional photodetectors and oscilloscopes. In an optical sampling system, the optical signal is sampled in the optical domain by a nonlinear optical sampling gate before the resulting samples are converted to an electrical signal. This avoids the need for high bandwidth electronics if the optical sampling gate is operated with a modest repetition frequency. In this paper, we present an optical sampling system using the optical Kerr effect in a highly nonlinear chalcogenide device, enabling combined capability for femtosecond resolution and broadband signal wavelength tunability. A temporal resolution 450-fs is achieved using four-wave mixing (FWM) in dispersion-engineered chalcogenide waveguides: on one hand a 7-cm long planar waveguide (integrated on a photonic chip) and on the other hand a 5-cm long tapered fiber. The use of a short length, dispersion-shifted waveguide with ultrahigh nonlinearity (10000/W/km) enables high-resolution optical sampling without the detrimental effect of chromatic dispersion on the temporal distortion of the signal and sampling pulses, as well as their phase mismatch (which in turn would degrade the FWM efficiency and the sensitivity of the measurement). Using these chalcogenide devices, we successfully monitor a 640-Gb/s optical time-division multiplexing (OTDM) datastream, showcasing its potential for monitoring of signals at bitrates approaching and beyond Tb/s. We compare the advantages and disadvantages of both approaches and discuss fundamental limitations as well as potential improvements.

Citation Download Citation

Jürgen Van Erps, Feng Luan, Mark D. Pelusi, Eric Mägi, Tim Iredale, Steve Madden, Duk Yong Choi, Douglas A. Bulla, Barry Luther-Davies, Hugo Thienpont, and Benjamin J. Eggleton "Optical sampling of ultrahigh bitrate signals using highly nonlinear chalcogenide planar waveguides or tapered fibers", Proc. SPIE 7728, Nonlinear Optics and Applications IV, 772803 (4 June 2010); https://doi.org/10.1117/12.853640

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

;

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE