Paper
18 August 2010 Assessment of ESD robustness in high power light emitting diodes
Shih-Chun Yang, Pang Lin, Han-Kuei Fu, Chien-Ping Wang, Tzung-Te Chen, An-Tse Lee, Sheng-Bang Huang, Pei-Ting Chou, Wei Wang, Fu-Jen Kao
Author Affiliations +
Abstract
The capability of high-power nitride-based light-emitting diodes (HPLED) to withstand electrostatic discharge (ESD) is very important key index due to the horizontal structure of the insulating property of the sapphire substrate. However, it is difficult to real-time monitor the damage caused by the ESD stress because it occurred in a very short period. Current-voltage (I-V) curves and electroluminescence (EL) spectrum were applied to study the change during the series ESD stress. Time-resolved optical beam induced current (TR-OBIC) was used to analyze the characteristics of the delay time between normal region and the defect point caused by ESD stress. Transmission electron microscopy (TEM) was used to compare to the difference in the distribution of damage region and investigate the failure modes. During the series ESD stresses, V-shaped pits suffered from the high electrical field and the distance from multi-quantum well (MQW). The bottom of V-shaped defect would be one of index to assess the ESD endurance of LED chips.
© (2010) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Shih-Chun Yang, Pang Lin, Han-Kuei Fu, Chien-Ping Wang, Tzung-Te Chen, An-Tse Lee, Sheng-Bang Huang, Pei-Ting Chou, Wei Wang, and Fu-Jen Kao "Assessment of ESD robustness in high power light emitting diodes", Proc. SPIE 7784, Tenth International Conference on Solid State Lighting, 778419 (18 August 2010); https://doi.org/10.1117/12.860322
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Light emitting diodes

Electroluminescence

Failure analysis

Transmission electron microscopy

Sapphire

Gallium nitride

Scanning electron microscopy

Back to Top